beautypg.com

Siemens C2-010 User Manual

Page 10

background image

C2-010 / C2-010-I ADSL2+ Router User’s Guide

2.3.4 Hub or Switch to ADSL2+ Router Connection

Connect the ADSL2+ Router to an uplink port on an Ethernet hub or switch with a straight-through cable

as shown in the diagram below:

Figure2-5 Hub/Switch to ADSL2+ Router Connection

If you wish to reserve the uplink port on the switch or hub for another device, connect to any on the other

MDI-X ports (1x, 2x, etc.) with a crossed cable.

2.4 Power

on

1) To power on the ADSL2+ Router, please follow the steps as instructed: Insert the AC Power Adapter cord

into the power receptacle located on the rear panel of the ADSL2+ Router and plug the adapter into a

suitable nearby power source.

2)

You should see the Power LED indicator light up and remain lit. The Status LED should light solid
green and begin to blink after a few seconds.

2-4