Simrad AP25 - Manual (Page 56)

Simrad AP25 Autopilot
54
20221495F
Compass
Select the compass to be used if more than one
compass is connected.
Note! Compass can only be selected in STBY mode
Navigation
Select a source for NAV mode steering.
Position
Select the source for position data and NoDrift mode.
Wind Apparent
Select the source for Apparent wind.
Wind Calculated
Select the source for Calculated Wind data for the
Simrad group. The autopilot uses internal source
irrespective of the selected source.
Water Speed
Select the source for water speed (normally the same
as the source providing Log data).
Water temperature
Select the source for water temperature (normally the
same as the source providing depth data).
DisLog
Select the Log source.
Depth
Select the source for depth data.
Depth source information
Set shallow water
Use the course knob to set the shallow water alarm limit.
Range: 0-100,0 m (0-328 ft.)
The setting of the alarm is local. In a multistation system,
however, the setting representing the shallowest water
limit will activate the alarm even if this setting is on an
“inactive” unit.
Note ! The shallow water alarm is activated only when digits are
dialled in.