SpectraLink h340 - Manual (Page 57)

SpectraLink Corporation Configuration and Administration—NetLink e340/h340/i640 Wireless Telephone
with SIP
PN: 72-1089-02-D.doc Page 57
Message Description Action
No IP Address Invalid IP. Check the IP address of the handset and
reconfigure if required.
No SIP DHCP DHCP is configured but no valid SIP option
43 was found.
Check DHCP configuration for option 43
and reconfigure if required.
No Net Access Cannot authenticate / associate with AP. Verify the AP configuration.
Verify that all the WEP settings in the
handset match those in the APs.
No Net Found
No APs
Handset cannot find any APs
This indicates any of the following:
No radio link. Verify that the AP is turned on.
No ESSID: Auto-learn not supported (or)
incorrect ESSID.
Verify the ESSID of the wireless LAN and
enter or Autolearn it again if required.
AP does not support appropriate data rates. Check the AP configuration against
Configuration Note for AP.
Out of range. Try getting closer to an AP. Check to see if
other handsets are working within the
same range of an AP. If so, check the
ESSID of this handset.
Incorrect Security settings. Verify that all the Security settings in the
handset match those in the APs.
No Net Found
xxxxxxxxxxxx yy
x…x = AP MAC address.
yy = AP signal strength.
Handset cannot find a suitable AP; displays
MAC and signal strength of “best” non-
suitable AP found.
Check AP and handset network settings
such as ESSID, Security, Reg domain and
Tx power.
Ensure APs are configured per
Configuration Note .
Try Site Survey mode to determine a more
specific cause.
No PBX Response The handset has exceeded its retransmission
limit with no ACK response from proxy server.
Verify that proxy server IP address and port
are properly configured.
No Reg Domain Regulatory Domain Not Set. Configure the Regulatory Domain of the
handset.
No SVP IP The handset is configured for “Static IP” (as
opposed to “use DHCP”), and no valid
NetLink SVP Server address has been
entered.
Enter a valid NetLink SVP server IP address
in the configuration setting or change to
“use DHCP.”
No SVP Response
yyy.yyy.yyy.yyy
y…y = SVP Server IP address.
Handset has lost contact with the SVP Server.
This may be caused by bad radio reception
or a problem with the NetLink SVP Server.
The handset will keep trying to fix the
problem for 20 seconds, and the message
may clear by itself. If it does not, the
handset will restart. Report this problem to
the system administrator if it keeps
happening.
No SVP Server Handset can’t locate NetLink SVP Server. IP address configuration of NetLink SVP
Server is wrong or missing.
NetLink SVP Server is not working. Check error status screen on NetLink SVP
Server.