SpectraLink h340 - Manual (Page 53)

SpectraLink Corporation Configuration and Administration—NetLink e340/h340/i640 Wireless Telephone
with SIP
PN: 72-1089-02-D.doc Page 53
11.3 Handset Status Messages
NetLink Wireless Telephone status messages provide information about the NetLink
e340/h340/i640 Wireless Telephone’s communication with the AP and host
telephone system. The following table summarizes, in alphabetical order, the status
messages.
Message Description Action
3 chirps (audio) Handset is not able to communicate with the
best AP, probably because that AP has no
bandwidth available.
None. This is only a warning, the call will
hand off to the best AP once it becomes
available.
Address Mismatch Handset software download files are
incorrect or corrupted.
Download new software from the
SpectraLink website per Software
Maintenance .
ASSERT xxx c
Line yyy
The handset has detected a fault from which
it cannot recover.
Record the error code so it can be
reported.
Turn the handset off then on again.
If error persists, try registering a different
handset to this telephone port.
If error still persists, contact SpectraLink
Technical Support and report the error.
Assoc Failed
xxxxxxxxxxxx
x…x = AP MAC address.
Handset association was refused by AP;
displays MAC of failing AP.
Check handset and AP security settings.
Ensure AP is configured per Configuration
Note .
Try another AP.
Assoc Timeout
xxxxxxxxxxxx
x…x = AP MAC address.
Handset did not receive association
response from AP; displays MAC of failing
AP.
Check handset and AP security settings.
Ensure AP is configured per Configuration
Note .
Try another AP.
Auth Failed
xxxxxxxxxxxx
x…x = AP MAC address.
Handset authentication was refused by AP;
displays MAC of failing AP.
Check handset and AP security settings.
Ensure AP is configured per Configuration
Note .
Try another AP.
Auth Timeout
xxxxxxxxxxxx
x…x = AP MAC address.
Handset did not receive authentication
response from AP; displays MAC of failing
AP.
Check handset and AP security settings.
Ensure AP is configured per Configuration
Note .
Try another AP.
Bad Code Type xx
Expected Code Type yy
xx, yy = software license types.
Handset software does not match current
handset license selection.
Download new software from the
SpectraLink website per Software
Maintenance .
Bad Config Some needed configuration parameter has
not been set.
Check all required handset configuration
parameters for valid settings.
Bad ESSID The handset is configured for “static ESSID”
(as opposed to “Learn once” or “Learn
always”), and no ESS ID has been entered.
Enter an ESSID in the configuration
settings or change to one of the “Learn”
modes.
Bad Phintl File Handset software download files are
incorrect or corrupted.
Download new software from the
SpectraLink website per Software
Maintenance .