Sanyo QXXAVC922---P - Manual (Page 56)

Chapter 6 Basic setting and operation
2
Registering and deleting E-mail addresses
Click "Add e-mail address" and type the e-mail address onto
the text box and click Set button. To check the registered
addresses, click Check/Delete sub menu tab. The addresses are
listed as the figure on the right.
✐ Up to 10 E-mail addresses can be registered.
To delete the registered addresses, check the address you want to
delete and click Delete button.
3
Option selection for sending alert mail
Click Option sub menu tab. Check the condition items under
which alert mail will be sent and click Set button.
Please refer to the item "Examples :Type and contents of alert
mail" described on the next page.
Check / Delete
Option
[1]––––––––––––––––––––––––––––––––––
o
When PJ lamp is off.
o
When PJ lamp replacement time is reached.
o When internal PJ power circuit is failed.
o When internal PJ temperature is too high.
o
When PJ is turned into Standby in proper user
operation.
[2]––––––––––––––––––––––––––––––––––
o
When accumulated filter use time reaches
[ ] hours.
o When Power management function turns PJ
lamp off.
o When the signal is interrupted.
o
When Auto Play is failed.
[3]––––––––––––––––––––––––––––––––––
o
When lamp Corres. Value reaches
[ ] hours.
Attached message
✐ If condition "When Auto Play is failed" is
checked, the trap is sent when the error occurs
during the auto display operation using with the
network viewer function (+p.109). For further
information of the error, refer to item "Auto
Display setting and control page [3]"(+p.124).
✐ The length of message should be less than 255
characters.
✐ Up to 99,999 hours can be set for use time.