Sanyo QXXAVC922---P - Manual (Page 107)

10
Error messages Cause and corresponding
Set up the parameter.
Error when the communication is executed. The parameter setting (host
name, capture port) has not been set.
➔
Check parameter setting (+p.88)
It has not been registered to PJ as
a group.
Error when Start Communication or Start real time capture is executed. The
IP address of the computer has not been registered.
➔
Register the IP address by using the web browser (+p.95)
Cannot be displayed as PJ is under
display.
Error when Start Communication or Start real time capture is executed. The
other capture, viewer or advanced card imager function is now operating.
➔
Wait until the communication function is available.
Cannot connect to PJ.
Cannot establish the connection with the projector when the Start com-
munication is executed, Terminate Communication, Capture transfer, Start
real time capture or End real time capture.
➔
Check connection of the network cable.
Cannot transfer data to PJ.
Cannot transfer the data to the projector when the Start Communication,
Terminate Communication, Capture transfer, Start real time capture or End
real time capture is executed. The time-out period is 10 seconds.
➔
Check the connection of the network cable.
Cannot receive data from PJ.
Cannot receive the data from the projector when the Start Communica-
tion, Terminate Communication, Capture transfer, Start real time capture or
End real time capture is executed. The time-out period is 10 seconds.
➔
Check the connection of the network cable.
Other PC has authority. Cannot
complete "Network Communica-
tion".
When executing the Terminate Communication, you cannot quit the com-
munication because other computer has an authority
Other PC has authority. Cannot
obtain authority.
Other computer has an authority.
Invalid port number
When the parameter is set, the reserved port number is specified.
➔
Check the parameter setting (+p.88)
PJ has not started Network Com-
munication. Close the window and
open it again.
The projector might have turned off during the communication.
➔
Check the projector power and re-execute "Start communication".
Error information
Error information