Sanyo QXXAVC922---P User Manual
Page 129
1
4. Type the commands, refer to below table, to control the projector and then press "Enter" key for
termination. For example, type "C00" which is a command to turn on the projector, and press "Enter"
key. Confirm the projector is turning on.
To disconnect the communication, press "Ctrl" key and "]" key at the same time.
The table below shows the typical command lists for controlling this projector and please consult your
local dealer for further information of another commands.
*1 Further instructions about the telnet application, please see the on-line guide on your computer.
*2 The password is a Network PIN code decided item "Network PIN code setting" (
+
p.30, 40). If the authen-
tication of the entered password is failed 4 times continuously, the communication will be disconnected
automatically. Please try again for the connection.
Command
Function
C00
Power on
C02
Power off
C09
Volume up
C0A
Volume down
C0B
Audio Mute on
C0C
Audio Mute off
C1C
Menu display on
C1D
menu display off
Command list table
Use of telnet