Sanyo QXXAVC922---P - Manual (Page 52)

Chapter 6 Basic setting and operation
2. Select either "Manual" or "DHCP" from IP configuration pull
down menu. When "DHCP" is selected, IP address, Subnet mask,
Default Gateway, DNS are automatically configured by DHCP
function. Only the DNS address allows you to set up manually
if the DNS address information is not provided on your DHCP
server. When selecting "Manual", configure all the items manu-
ally. For further information, contact your network administra-
tor.
The address must be entered as 4 number groups separated
by a dot like [192.168.001.101].
3. After completing the network configuration, press Regist but-
ton to register the network information. The Simple(Wireless)
setting is fixed, which cannot be changed from factory default
value.
4. To apply the setting, press Set button. The network of the pro-
jector starts re-booting and applies the setting. It takes about 20 seconds to complete. Close the web
browser and access to the login page again in 20 seconds.
On the screen of the projector, the “Please wait...” message will appear and switching operation will
start. Switching will take a while and after completing the operation, the “Ready for use” message
will appear. During the switching period, the projector cannot be operated.
When you use LAN4(wireless) or LAN5(Wireless), the setting items of page [2] and [3] are activated
and you can setup Wireless LAN setting and Security setting. See the item "Wireless LAN Setting
and Security Setting" for further setting.