Sanyo QXXAVC922---P - Manual (Page 35)

4. Press SELECT button. LAN setting screen will appear and the selected LAN settings will be displayed.
Adjust each item to the setting environment. Consult your system administrator for the detailed
settings.
Adjust the figures with the Point ed buttons and move among the items with the Point 7 8
buttons. When the network type is “AdHoc”, you do not have to change “Sub net” and “Gateway” and
leave them as default settings.
SSID/ESSID for the network type “Infrastructure” and “AdHoc” are required to be entered the same
characters into the projector, the access point, and the Wireless LAN compatible computer (up to 32
characters). Characters can be selected from A~Z, a~z, blank (space), 0–9, or - (hyphen) with the Point
ed buttons. Move to the next character with the Point 7 8 buttons.
You can confirm that the projector settings from “Network Information” in the projector menu (p.40).
5. After completing all the settings, select “Set” and press SELECT button. Now, all procedures have
been done. To cancel the adjusted settings, select the "Cancel" and press SELECT button.
To confirm whether the settings are correct, follow the procedures in “4. Wired LAN configurations”
➔
“Confirming the Operation” (p.28).
For configuring of WEP, WPA-PSK,
WPA2-PSK security, select “Next”. Refer
to “Configuring security with the
projector” on next page for details.
Item Description
DHCP .......................... Sets DHCP function On or Off. When you setup the network setting manually, select "Off". When
its set On, IP address, Subnet, Gateway and DNS are automatically set according to your network
environment *
1 .
IP address .................Sets IP address of the projector
Subnet .......................Sets Subnet mask. Normally sets 255.255.255.0
Gateway*
2 .................Sets IP address of the default gateway (Router)
DNS* 2 .......................... Sets IP address of the DNS server. Must be set when the e-mail function is used.
Network type .......... Sets Infrastructure or AdHoc mode. When the "AdHoc" is selected, the security "WPA-PSK" and
"WPA2-PSK" are not available.
SSID/ESSID ...................Identifier of the wireless access point.
*1 Set "On" only when the DHCP server is available on your network environment.
*2 Set [255.255.255.255] if the network does not provide the gateway (router).
*3 Set [255.255.255.255] if you do not use the function E-Mail alert.
* While the network communication function (p.85) or moderator function (p.103) is to be executing, the menus
"Network capture", "Network viewer" and "Memory viewer" are displayed in gray.
Setting the network environment