Sun Microsystems Sun Adapter IP HL 7 - Manual (Page 62)

HL7 Recourse Action — TCP/IP HL7 V2 Outbound
Adapter
The following table lists and describes the properties that appear on the HL7 Recourse Action
page of the Properties Editor accessed from the Connectivity Map. These properties define the
actions the adapter takes when operations occur outside the configured constraints.
TABLE 26 Connectivity Map - HL7 Recourse Action
Name Description
Action on No Response The action the adapter takes when no ACK is received from the external system in
the allotted time. The amount of time is determined by the Time To Wait For A
Response
property (see Communication Control ). Select one of the following
options:
■ Exit – The adapter terminates its connection with the external system and
shuts down.
■ Resend – The adapter attempts to resend the message to the external system.
The Resend option is only allowed when sequence numbering is in effect.
■ Reset – The adapter closes its connection with the external system and goes
through the connection scenario.
This property is used for outbound Collaboration code.
Action on Max No
Response The action the adapter takes when it attempts to send a message to the external
system the maximum allowed number of times and does not receive any response
(HL7 Application Acknowledgement) from the external system. The maximum
number times the adapter sends a message without receiving a response is
determined by the Max No Response property (see
Communication Control ).
Select one of the following options:
■ Exit – The adapter terminates its connection with the external system and
shuts down.
■ Reset – The adapter closes its connection with the external system and goes
through the connection scenario.
This property is used for outbound Collaboration code.
Action on Max Failed
Read Retry The action the adapter takes after it has reached the empty read limit set by the
Max Empty Read Retry
property. Select one of the following recourse options:
■ Exit – The adapter terminates its connection with the external system and
shuts down.
■ Reset – The adapter closes its connection with the external system and goes
through the connection scenario.
This property is used for outbound Collaboration code.
TCP/IP HL7 V2 Adapter Outbound Connectivity Map Properties
Sun Adapter for TCP/IP HL7 User's Guide • October 2009 62