Sharp MD X5 - Manual (Page 40)

39
REMEDY
• Insert properly.
• Replace the batteries.
• Operate it within a range of 8" (0.2 m) to 20' (6 m)
and within an angle of 15° to either side of center.
• Connect the AC power cord.
MD recording and playback
SYMPTOM
• A recording cannot be made.
• Even though a disc has been
loaded, “NO DISC” or “ERROR” is
displayed.
• Playback sounds are skipped.
Radio reception
SYMPTOM
• Radios make unusual noise
consecutively.
• The preset channel cannot be
called.
Remote control
SYMPTOM
• The remote control does not
function or does not operate
properly.
• The power cannot be turned on
from the remote control.
POSSIBLE CAUSE
• Is the MiniDisc protected against accidental erasure?
• Did you try to record on a playback-only MiniDisc?
• Can you see the “TOC FULL” message in the dis-
play?
• The disc is very dirty.
• Is the unit located near excessive vibrations?
• Has condensation formed inside the unit?
REMEDY
• Slide the accidental erase prevention tab back to
its original position.
• Replace it with a recordable disc.
• Put in another recordable disc with recording
space on it.
• Clean the disc.
• Place the unit on a firm, level surface free from
vibration.
• Remove the disc and leave the power turned on.
The unit should function properly in about 1 hour.
POSSIBLE CAUSE
• The unit is placed near the TV or computer.
• The antenna direction is not placed properly.
• Did a power failure occur?
REMEDY
• Place the unit apart from the noise.
• Correct the antenna direction.
• Preset the channel again.
POSSIBLE CAUSE
• The batteries (polarity) are not inserted properly.
• The batteries inside the remote control are dead.
• The remote control is operated from an incorrect
distance or angle.
• Is the AC power cord plugged in?
H H H H H
If a problem occurs
If this product is subjected to strong external interference (mechanical
shock, excessive static electricity, abnormal supply voltage due to light-
ning, etc.) or if it is operated incorrectly, it may malfunction or the display
may not function correctly. If such a problem occurs, do the following:
1
Unplug the AC power cord from the AC outlet.
2
Press the RESET button on the back of the unit for at least 3 seconds.
3
Plug the AC power cord back into the AC outlet.
I
When the RESET button is pressed, all of the settings in memory will be
erased.
I
If strange sounds, smells or smoke come out of the unit, or if a foreign
object falls into the unit, turn off the power, unplug the AC power cord
from the AC outlet immediately. Contact an authorized Sharp Servicer.
(Continued)
RESET
*35-40 98.6.23, 10:11 AM 39