Sharp MD X5 - Manual (Page 12)

11
H H H H H
Tuning
1
Press the TUNER (BAND) button.
I
The power is turned on, and the tuner is selected.
2
Press the TUNER (BAND) button to select the desired frequency band
(FM or AM).
3
Tune in to the desired station using the TUNING
X
or
W
button.
Auto tuning:
When the TUNING
X
or
W
button is pressed for more than 0.5 seconds
and then released, the tuning stops at the first receivable broadcast station.
Notes:
I
When radio interference occurs during auto tuning, auto tuning may
stop automatically at that point.
I
If a weak station signal is found during auto tuning, the station will be
skipped.
I
To stop auto tuning, press the TUNING
X
or
W
button again.
Manual tuning:
Press the TUNING
X
or
W
button as many times as necessary to adjust
the frequency display to the frequency of the desired station.
4 To receive FM stereo, press the ST-MODE button on the remote control
so that the "STEREO" indicator appears.
I
“ST” will appear when an FM broadcast is in stereo.
5
If the FM stereo reception is weak, press the ST-MODE button so that
the “STEREO” indicator goes out.
I
Although the reception changes to monaural, the sound becomes
clearer.
After use:
Press the POWER button to turn the power off.
Direct playback:
Just pressing the TUNER (BAND) button will turn on the power automati-
cally. The radio station you were listening to last will be tuned in.
Notes:
I
The memory recalls the last station received even after changing the
TUNER (BAND) button or function selector buttons, or pressing the
POWER button to turn the power off.
I
If you are listening to the radio near personal computers, radios, or TV
sets, various noise or interference may be heard. Keep this unit as far
away as possible from these products.
RADIO OPERATION
4,5
1,2 3
1,2
3
Frequency
FM stereo reception indicator
Stereo mode indicator
*01-21 98.6.23, 10:09 AM 11