Sharp MD X5 - Manual (Page 14)

13
CD AND MD OPERATIONS
H H H H H
Direct-selection play
By using the track number input buttons on the remote control, any track
you wish to can be played directly, by entering its number.
1
Select the desired program source, CD or MD, by pressing the CD
H
or
MD
H
button.
2
Use the track number input buttons to select the desired track number.
A. To select track numbers 11 to 99
Press the >10 button first, then press the track number.
For example to select 28:
1 Press the >10 button.
2 Within 5 seconds, press the "2" button.
3 Within 5 seconds, press the "8" button.
B. To select track number 100 or higher (only for MD)
Press the >10 button twice, then press the track number.
For example to select 105:
1 Press the >10 button.
2 Within 5 seconds, press the >10 button.
3 Within 5 seconds, press the "1" button.
4 Within 5 seconds, press the "10/0" button.
5 Within 5 seconds, press the "5" button.
The beginning of the selected track will be found, and play will begin
automatically.
Notes:
I
A track number higher than the number of tracks on the disc cannot be
selected.
I
During APMS play or random play, track number selection play is not
possible.
H H H H H
APSS (Auto Program Search System)
APSS automatically locates the beginning of any track.
To listen again to the track being played:
Press the
5
button for less than 0.5 seconds during playback.
To move to the beginning of the next track:
Press the
4
button for less than 0.5 seconds during playback.
I
To skip a number of tracks at one time, press the
5
or
4
button
repeatedly until the desired track number is shown.
I
To start playback from a desired track, press the
5
or
4
button while
in the stop mode to select the track number, and then press the
06
button.
H H H H H
Cue and review
1
Load a disc and begin playback.
2
Hold down the
4
button for audible fast forward, and hold down
the
5
button for audible fast reverse.
3
Normal playback will resume when the
4
or
5
button is
released.
Notes:
I
If the end of the disc is reached while cueing, “DISC END” will
appear on the display, and operation will pause. Press the CD
H
or MD
H
button to stop operation.
When you want to listen to the disc again, press the
5
button to
locate the desired track. Normal playback will start from that point.
I
When the beginning of the first track is reached, normal playback
will start.
To search very quickly
When fast forward or fast reverse is used while in the pause mode, the
playback point will move more quickly than when using audible fast
forward or audible fast reverse in the playback mode.
I
In this mode, no sound is heard. Therefore, you must refer to the
time display.
I
When you lift your finger, the unit will re-enter the pause mode.
4
5
4
4
5
5
Track number
input buttons
*01-21 98.6.23, 10:09 AM 13