JVC SR-VS30E - Manual (Page 64)

Filename [SR-VS30EK_3-EN.fm]
Masterpage:Left
64
Page 64 February 1, 2002 2:04 pm
SYSTEM CONNECTIONS (cont.)
Connecting To A Satellite Receiver
Connect the satellite receiver to the AV2 (L-2) IN/
DECODER connector, then connect the AV1 (L-1) IN/
OUT connector to the TV’s connector. NOTES:
● Set “L-2 SELECT” to “A/V” ( ੬
pg. 53).
● To record a programme via the satellite receiver, select L-2
mode by pressing AUX (number key “0”) and/or PR so that
“L-2” appears on the front display panel.
● For details, refer to the instruction manual of the satellite
receiver.
IMPORTANT
When you set “L-2 SELECT” to “SAT” (
੬
pg. 53), it is possible to view a satellite broadcast with the TV set to its AV mode even if
the recorder is in timer mode, in stop mode, in recording mode or turned off. When the recorder is in Stop mode or recording,
press TV/VCR on the remote control to turn off the VCR indicator on the front display panel.
● Set “L-1 OUTPUT” to “VIDEO” and set the satellite receiver’s output and the TV’s input to the composite mode.
● When the recorder is turned off, only a composite signal is output from the recorder to TV.
● If you turn on the recorder when the satellite receiver’s power is off, nothing appears on the TV screen. In this case, turn on the
satellite receiver, or set the TV to its TV mode, or press TV/VCR on the remote control to set the recorder to the video mode.
S OUT
SORTIE
ANTENNA
ANTENNE
IN
ENTREE
OUT
SORTIE
AUDIO
L
R
SAT CONTROL
CONTROLEUR SAT
OUT
SORTIE
AV2 (L-2) IN/DECODER
ENTREE/DECODEUR
AV1 (L-1)
IN/OUT
ENTREE/SORTIE
DECODER VCR TV
Outdoor unit
Satellite cable
Satellite receiver
Aerial
TV aerial
cable
21-pin SCART connector
Back of TV
ANTENNA IN
ANTENNA OUT
Aerial
connector
Mains outlet
Back of recorder
SR-VS30EK_1.book Page 64 Friday, February 1, 2002 2:31 PM