beautypg.com

Basic connections – JVC SR-VS30E User Manual

Page 11

background image

Masterpage:Right-NoTitle0

11

Filename [SR-VS30EK_1-EN.fm]

Page 11

February 19, 2002 7:10 pm

Basic Connections

It’s essential that your video recorder be properly
connected.

A

Situate the recorder.

Place the recorder on a stable, horizontal surface.

B

Connect the recorder to TV.

A Disconnect the TV aerial cable from the TV.

B Connect the TV aerial cable to the ANTENNA IN

connector on the rear panel of the recorder.

C Connect the provided RF cable between the

ANTENNA OUT connector on the rear panel of the
recorder and the TV’s aerial connector.

D Connect the 21-pin SCART cable between the AV1

(L-1) IN/OUT connector on the rear panel of the
recorder and the TV’s 21-pin SCART connector.

● The AV1 (L-1) IN/OUT connector accepts and delivers either a

composite signal (regular video signal) or a Y/C signal (a signal
in which the luminance and chrominance signals are
separated). If your TV’s 21-pin AV input connector (SCART) is
compatible with the Y/C signal, set “L-1 OUTPUT” to
“S-VIDEO” after the connection and the initial settings are
completed (

pg. 52). You can obtain high-quality S-VHS

pictures. (For connection, be sure to use a 21-pin SCART cable
that is compatible with the Y/C signal.)

● Set your TV to the VIDEO (or AV), Y/C, or RGB mode

according to the type of your TV’s SCART connector.

● For switching the TV’s mode, refer to the instruction manual of

your television.

● To obtain high-quality S-VHS pictures, you can also use the

S-VIDEO connection described on page 12.

C

Connect the recorder to mains.

Plug the end of the mains power cord into a mains outlet.

ATTENTION:

Your TV must have a 21-pin AV input connector
(SCART) for the connection to the recorder.

Aerial connector

Back of TV

21-pin SCART
connector

TV aerial cable

RF cable
(provided)

21-pin SCART

cable

(not provided)

Mains power cord

Mains outlet

Back of recorder

AV1 (L-1)
IN/OUT

ANTENNA
IN

ANTENNA
OUT

THESE STEPS MUST BE COMPLETED BEFORE ANY
VIDEO OPERATION CAN BE PERFORMED.

After the connection is completed, perform “Auto Set
Up” on page 13.

SR-VS30EK_1-EN.fm Page 11 Tuesday, February 19, 2002 7:10 PM