Sony KDF-E42A10 - Manual (Page 15)

Introducing the TV
15
Introd
ucin
g the
TV
KDF-E42A10/KDF-E50A10
2-597-544-12(1)
D:\WINNT\Profiles\noriko\Desktop\Troy EN2\2597544121\01US03WEL.fm masterpage:3 columns Right
TV Controls and Connectors
Front Panel
PUSH OPEN
WEGA GATE
TV/VIDEO CANNEL VOLUME
POWER TIMER LAMP POWER/STANDBY
PUSH OPEN POWER/STANDBY POWER
WEGA GATE
TV/VIDEO CHANNEL VOLUME
TIMER LAMP
2 1 5 9 3 4 6 7 8
0
To open the panel
To open the front panel of your
TV, push up the panel door just
under the "PUSH OPEN" mark.
Item Description
1 WEGA GATE Press to display WEGA GATE and activate the , B , b , v , and V buttons. Press again to exit
WEGA GATE and activate the TV/VIDEO, – VOLUME + and – CHANNEL+ buttons.
2
TV/VIDEO
Press to confirm the selection or setting.
Press repeatedly to cycle through the video equipment connected to the TV’s video inputs.
3
– VOLUME +
Press to adjust the volume.
4
– CHANNEL +
Press to scan through channels. To scan quickly through channels, press and hold either – or +.
5 TIMER LED When lit, indicates one of the timers or Sleep is set. When it is set, this LED will remain lit even if
the TV is turned off. For details, see page 83.
6 LAMP LED Lights up in red when the lamp for the light source has burned out. For details, see “Replacing the
Lamp” on page 86.
7 POWER/
STANDBY LED Lights up in green when the TV is turned on. If the LED blinks in red continuously, this may
indicate the display unit needs servicing (see “Contacting Sony” on page 2). When the red LED
blinks only three times, the lamp door of the lamp unit or the lamp itself is not securely attached
(see page 88).
8 (IR) Infrared
Receiver Receives IR signals from the remote control.
Do not put anything near the sensor, as its function may be affected.
9 POWER Press to turn on and off the TV.
q; Speaker Outputs audio signal.
✍
The CHANNEL + button has a tactile dot. Use the tactile dot as a reference
when operating the TV.