Siemens CL-010 - Manual (Page 53)

Chapter 5:Connection Mode
PPP over ATM/ PPP over Ethernet
If the type you choose is PPP over ATM or PPP over Ethernet, please refer to the following
information.
According to the ISP’s configuration on the
server, you can choose PPPoE and PPPoA
modes. If the ISP provides PPPoE service,
the connection type selection will be decided
as whether the LAN side device is running a
PPPoE client or the router is to run the
PPPoE client. This router supports both
situations simultaneously.
Choose PPPoA or PPPoE and click Next.
In this screen, you have to choose the
settings for WAN IP. To get the IP address
automatically, click the Obtain an IP
address automatically radio button. Or
click Use the following IP address button
and enter the IP address for WAN interface.
Click Enable NAT if you want. As for the
detailed NAT settings, it will be described in
later sections.
Click Enable QoS for your necessity.
It can improve the performance for selected
classes of applications. Before you check
this item, please assign the priorities for
various applications from the Quality of
Service menu of Advanced web page. Be
aware that IP QoS also consumes system
resources, the number of created PVCs will
be reduced consequently.
The MTU means the maximum size of the
packet that transmitted in the network. The
packet of the data greater than the number
set here will be divided into several packets
for transmitting. Type in the number into the
field of MTU. The default setting is 1492.
Click Next for next screen.