SUPER MICRO Computer 6113L-8 - Manual (Page 70)

6-8
S UPER S ERVER 6113L-8/6113L-i User's Manual
CD-ROM Drive Installation
The top cover of the chassis must be opened to gain full access to the CD-ROM
drive bay. The 6113L-8/6113L-i accomodates only slim CD-ROM drives. Side
mounting brackets are needed to mount a slim CD-ROM drive in the 6113L-8/
6113L-i server.
You must power down the system before installing or removing a CD-ROM drive.
First, release the retention screws that secure the server unit to the rack. Grasp
the two handles on either side and pull the unit straight out until it locks (you will
hear a "click"). Next, depress the two buttons on the top of the chassis to
release the top cover and at the same time, push the cover away from you until
it stops. You can then lift the top cover from the chassis to gain full access to
the inside of the server.
With the chassis cover removed, unplug the power and data cables from the drive.
Then locate the locking tab at the rear of the drive. It will be on the left side of
the drive when viewed from the front of the chassis. Pull the tab away from the
drive and push the drive unit out the front of the chassis. Add a new drive by
following this procedure in reverse order. You may hear a faint *click* of the
locking tab when the drive is fully inserted. Remember to reconnect the data and
power cables to the drive before replacing the chassis cover and restoring power
to the system.