SUPER MICRO Computer 6113L-8 - Manual (Page 49)

Chapter 5: Advanced Serverboard Setup
5-13
5-6 Adding PCI Cards
1. PCI-X slot:
The i2DML-8G2/i2DML-iG2 has one 64-bit 133 MHz PCI-X slot. The server
should have come with a riser card installed, which supports a standard sized
PCI-X card (see Figure 5-7).
2. PCI card installation:
Before installing a PCI add-on card, see step 1, above. Begin by swinging
the release tab on the I/O backpanel shield out to the left for the PCI slot.
Insert the PCI card into the correct slot on the butterfly riser card (depending
on whether it is a standard or low-profile card), pushing down with your
thumbs evenly on both sides of the card. Finish by pushing the release tab
back to its original (locked) position. Follow this procedure when adding a
card to either slot.
Figure 5-7. Low Profile vs. Standard PCI Card Form Factor
Low Profile PCI
Expansion Card
Standard PCI
Expansion Card