SUPER MICRO Computer 6113L-8 - Manual (Page 13)

1-3
Chapter 1: Introduction
Processors
The i2DML-8G2/i2DML-iG2 supports single or dual Intel Itanium2 processors of
up to 1.50 GHz with a 6 MB L3 cache at a 400 MHz FSB. Please refer to the
support section of our web site for a complete listing of supported processors
(http://www.supermicro.com/support/).
Memory
The i2DML-8G2/i2DML-iG2 has eight 184-pin, DIMM slots that can support up to
16 GB of low-profile, registered ECC DDR200 (PC1600) SDRAM (DDR266 is
supported but at 200 MHz only). Module sizes of 128 MB, 256 MB, 512 MB, 1
GB and 2 GB may be used to populate the DIMM slots. (This serverboard has
has been designed to support 2GB DIMM modules for each memory slot, but it has
only been validated with 1GB memory modules.)
PCI Expansion Slots
The i2DML-8G2/i2DML-iG2 has one 64-bit, 133/100 MHz PCI-X slot available for
use in a 1U server configuration. A riser card is included with the server. This
riser card fits into a PCI-X slot on the serverboard and was designed specially for
the SC813HS-500/SC813Hi-500 chassis to support the use of one standard (full-
length) PCI-X card.
ATI Graphics Controller
The i2DML-8G2/i2DML-iG2 features an integrated ATI video controller based on
the Rage XL graphics chip. Rage XL fully supports sideband addressing and AGP
texturing. This onboard graphics package can provide a bandwidth of up to 512
MB/sec over a 32-bit graphics memory bus.
Onboard Controllers/Ports
The i2DML-8G2 (only) includes an onboard LSI Ultra320 SCSI controller for dual-
channel operation. Backpanel I/O ports on the 6113L-8/6113L-i include two COM
ports, two USB ports and a VGA (monitor) port. An Intel 82546EB Ethernet
controller provides support for two Gb LAN ports, which are also located on the
backpanel.