Chapter 5 advanced serverboard setup, Precautions – SUPER MICRO Computer 6113L-8 User Manual
Page 37
Chapter 5: Advanced Serverboard Setup
Chapter 5
Advanced Serverboard Setup
This chapter covers the steps required to install processors and heatsinks to the
i2DML-8G2/i2DML-iG2 serverboard, connect the data and power cables and in-
stall add-on cards. All serverboard jumpers and connections are described and
a layout and quick reference chart are included in this chapter. Remember to
close the chassis completely when you have finished working on the serverboard
to protect and cool the system sufficiently.
5-1
Handling the i2DML-8G2/i2DML-iG2 Serverboard
Static electrical discharge can damage electronic components. To prevent dam-
age to printed circuit boards, it is important to handle them very carefully (see
Chapter 4). Also note that the size and weight of the serverboard can cause it
to bend if handled improperly, which may result in damage. To prevent the
serverboard from bending, keep one hand under the center of the board to support
it when handling. The following measures are generally sufficient to protect your
equipment from static discharge.
Precautions
•
Use a grounded wrist strap designed to prevent static discharge.
•
Touch a grounded metal object before removing any board from its antistatic
bag.
•
Handle a board by its edges only; do not touch its components, peripheral
chips, memory modules or gold contacts.
•
When handling chips or modules, avoid touching their pins.
•
Put the serverboard, add-on cards and peripherals back into their antistatic
bags when not in use.
Unpacking
The serverboard is shipped in antistatic packaging to avoid static damage. When
unpacking the board, make sure the person handling it is static protected.
5-1