Smeg A2PY-6 - Manual (Page 17)

Instructions for the User
58
Starting cooking: as well as setting a cooking duration, the cooking
start time can also be set (with a maximum delay of 12 hours from the
current time). To set the cooking start/end time, proceed as follows:
-
Set the cooking duration as described in the previous point.
-
Press the key again and hold it down. The current time appears
on the display: use the and keys to set the cooking start time.
-
A few seconds after the last key is pressed, the cooking start time
will appear on the display.
-
At the start of a programmed cooking operation, the dot between 12
and 1 will also illuminate, indicating that this is a programmed
cooking procedure.
-
To view the current time at any moment, press the key. After a
few seconds, the cooking start time will return to the display.
-
At the end of the cooking time the timer will switch the oven heating
elements off, the beeps will start to sound and the numbers on the
dial will flash.
-
To reset the whole program set, keep the central key pressed for
a few seconds: if cooking has already started, the oven will have to
be switched off by hand.
At the end of programmed cooking, manual operation of the oven
has to be restored by holding down the key for a few seconds.
Caution: for the oven to start cooking operations after the
programming procedures just described, the thermostat and
function selector knob must be correctly set on the temperature
and function required.
5.2.4
"DEMO" Function
Models with analogue/digital programmer feature a "DEMO" function
which deactivates the heating elements while leaving the other functions
unchanged. To activate it, simply press the , , and keys for a few
seconds. A confirmation beep will inform the user that the function is
active.
Once the display shows the current time with the demo function activated,
the number 6 will flash.
To deactivate it, simply repeat the same procedure.