Smeg A31G7IXIA User Manual
Smeg Radio
37
Contents
INSTRUCTIONS FOR THE USER: these contain user advice, description
of the commands and the correct procedures for cleaning and maintenance
of the appliance
INSTRUCTIONS FOR THE INSTALLER: these instructions are intended
for the
qualified technician who must perform the installation, put it into
operation and test the appliance
1. INSTRUCTIONS FOR USE ........................................................38
2. INSTRUCTIONS FOR DISPOSAL – OUR CONCERN FOR THE
ENVIRONMENT..........................................................................39
3. SAFETY INSTRUCTIONS ..........................................................40
4. GET TO KNOW YOUR APPLIANCE ..........................................42
5. BEFORE INSTALLATION...........................................................43
6. USING THE HOB........................................................................44
7. CLEANING AND MAINTENANCE ..............................................57
8. INSTALLING THE APPLIANCE..................................................60
9. GAS CONNECTION ...................................................................64
10. ADAPTATION TO DIFFERENT TYPES OF GAS.......................66
11. FINAL OPERATIONS FOR GAS APPLIANCES.........................68
Document Outline
- 1. INSTRUCTIONS FOR USE
- 2. Instructions for disposal – Our concern for the environment
- 3. Safety instructions
- 4. GET TO KNOW YOUR APPLIANCE
- 5. BEFORE installation
- 6. using the HOB
- 6.1 Gas hob
- 6.2 Practical tips for using the burners
- 6.3 Pan diameters
- 6.4 Glass ceramic hob
- 6.4.1 Cooking guidelines
- 6.6.1 Some good frying tips
- 6.6.2 When the frying is finished
- 6.7.1 Cooking zones
- 6.7.2 Heating accelerator
- 6.7.3 Operating power settings
- 6.7.4 Cookware
- 6.7.5 Cookware detector signal
- 6.7.6 Residual heat
- 6.7.7 Cooking hob lock-out
- 6.7.8 Circuit board thermal protection
- 6.7.9 Glass ceramic hob thermal protection
- 6.7.10 Warming function
- 7. CLEANING AND MAINTENANCE
- 8. INSTALLING THE APPLIANCE
- 9. Gas Connection
- 10. ADAPTATION TO DIFFERENT TYPES OF GAS
- 10.1 Replacement of nozzles on the hob
- 1 Extract the pan stands and remove all the caps and flame-spreader crowns;
- 2 Unscrew the burner nozzles with a 7 mm socket wrench;
- 3 Replace the burner nozzles according to the type of gas to be used (see point "10.2 Burner and nozzle characteristics table").
- 4 Replace the burners in the correct position.
- 10.2 Burner and nozzle characteristics table
- 10.1 Replacement of nozzles on the hob
- 11. FINAL OPERATIONS FOR GAS APPLIANCES