Woodstock SHOPFOX W1813 - Manual (Page 30)

-28-
N(/(*(/Fg\e
D
8
@EK<
E8E:
<
*% Clean away any debris and built-up grime from the
surfaces of the ways, then apply a thin coat of ISO
68 lubricant or an equivalent.
+% Move the sanding cabinet through its entire elevation
range of motion to evenly distribute the oil.
KffcjE\\[\[ Hkp
Hex Wrench 4mm ...............................................1
KfclYi`ZXk\k_\\c\mXk`fe^\Xij#[fk_\j\jk\gj1
(% DISCONNECT THE SANDER FROM POWER!
)% Loosen the set screw in the elevation handwheel
hub, then remove the handwheel to access the ele-
vation gears, as shown in
=`^li\),.
*% Use a shop rag and solvent to clean away debris and
grime from the gears, then use a brush to apply a
thin coat of NLGI #2 grease or an equivalent.
+% Re-install the handwheel, then move the sanding
cabinet up and down to evenly distribute the grease.
=`^li\),% Elevation gears (elevation
handwheel removed).
8`iI\^lcXkfi&=`ck\i
The air regulator filters the moisture from the incoming
compressed air and deposits the collected water in the
filter reservoir (see
=`^li\)-).
To empty the filter reservoir, make sure there is incom-
ing air pressure, then press the drain valve up. This will
release a flow of air and the collected water from the
reservoir.
=`^li\)-% Air regulator filter reservoir
and drain valve.
Filter
Reservoir
Drain
Valve