Fcc class b notice – Sun Microsystems 805-1797-10 User Manual

Page 60

Shielded Cables: Connections between the workstation and peripherals must be
made using shielded cables in order to maintain compliance with FCC radio
frequency emission limits. Networking connections can be made using unshielded
twisted-pair (UTP) cables.

Modifications: Any modifications made to this device that are not approved by Sun
Microsystems, Inc. may void the authority granted to the user by the FCC to operate
this equipment.

FCC Class B Notice

This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions:

1. This device may not cause harmful interference.

2. This device must accept any interference received, including interference that may

cause undesired operation.

Note -

This equipment has been tested and found to comply with the limits for a

Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following
measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.

Consult the dealer or an experienced radio/television technician for help.

Modifications: Any modifications made to this device that are not approved by Sun
Microsystems, Inc. may void the authority granted to the user by the FCC to operate
this equipment.

Sun Quad FastEthernet PCI Adapter Installation and User’s Guide

♦

Revision A, August 1997