Sun Microsystems 805-1797-10 - Manual (Page 27)

3. Create an appropriate entry in the /etc/hosts file for each active qfe channel.
Using the example in Step 1 on page 11, you will have:
# cat /etc/hosts
#
# Internet host table
#
127.0.0.1
localhost
129.144.10.57 zardoz loghost
129.144.11.83 zardoz-11
129.144.12.41 zardoz-12
129.144.13.67 zardoz-13
129.144.14.30 zardoz-14
4. Reboot your system.
Booting From the Network
To use a Sun Quad FastEthernet PCI adapter ethernet interface as the boot device,
perform the following tasks:
1. At the ok prompt type:
ok show-devs
The show-devs command lists the system devices. You should see the full path
name of the qfe devices, similar to the example below:
/pci@1f,2000/pci@2/SUNW,qfe@0,1
/pci@1f,2000/pci@2/SUNW,qfe@1,1
/pci@1f,2000/pci@2/SUNW,qfe@2,1
/pci@1f,2000/pci@2/SUNW,qfe@3,1
Note - You need to select only one of these qfe devices for booting.
2. At the ok prompt type:
ok boot (full path name of the
qfe device)
Configuring the Driver Software 13