Samsung CDI-E090-010 - Manual (Page 34)

28
Using the LCD Monitor
The LCD monitor can be used to confirm an image during shooting, to replay
recorded images or to adjust menu settings. Pressing the
button switches
the LCD monitor display mode.
2 Shooting Mode
Pressing the
button cycles the LCD monitor to the next mode each time
the button is pressed.
On (No Information)
➝ On (Information View) ➝ Off
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
• The on/off setting of the LCD monitor display mode is memorized when the
camera is turned off. When the camera is turned on again it assumes the last
mode. However, when the LCD monitor is turned on and the “Change the Battery
Pack” message appears, the LCD monitor may not automatically turn on the next
time the camera is started.
• When the LCD monitor is set to On (No Information) or Off, shooting information
appears for approximately 6 seconds when you take any of the following actions.
• The power is turned on.
• The
, or button is pressed.
• The focus is set with the manual focus.
• The aperture value and the shutter speed have been set with the
multicontroller’s
CDBA buttons.
• The Shooting mode is changed.
• Setting the mode dial to or turns on the LCD monitor regardless of
whether it is set to on or off.
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
The camera shake warning icon will appear on the LCD monitor in low light
conditions while the camera is preparing to shoot. When this icon appears, set the
flash to On or Auto, or fix the camera to a tripod to shoot.
2 Replaying Mode
•
The LCD monitor turns on when you turn on the camera in Replaying mode.
• Pressing the button cycles the information view mode each time the
button is pressed.
Single Replay (p. 105): Simple Display
➞ Detailed Display ➞ No Display
Index Replay (p. 107): Simple Display No Display