Sanyo VM4500 - Manual (Page 26)

Charging the Battery
Your PCS Phone comes with a rechargeable battery. You should
charge the battery as soon as possible so you can begin using
your phone.
Keeping track of your battery’s charge is important. If your battery
level becomes too low, your phone automatically turns off and you
will lose all the information you were just working on. For a quick
check of your phone’s battery level, glance at the battery charge
indicator located in the upper-right corner of your phone’s display
screen. If the battery charge is getting too low, the battery icon
blinks and the phone sounds a warning tone.
Always use a Sprint-approved desktop charger, travel charger, or
vehicle power adapter to charge your battery.
Warning! Using the wrong battery charger could cause damage to your phone
and void the warranty.
Using the Travel Charger
To use the travel charger provided with your phone:
1. Plug the travel charger into a wall outlet.
2. Plug the other end of the travel charger into the bottom of your
phone (with the battery installed).
ⅷ Charging when your phone is turned on:
The battery icon
appears on the display while charging.
The battery icon turns to when charging is complete.
ⅷ Charging when your phone is turned off:
The battery icon
appears, and the message “BATTERY
CHARGING-Power Off-” is shown on the display while
charging. When the battery is completely discharged, you
may wait for several minutes until the message is shown on
the display. The battery icon turns to
, and the message
changes to “CHARGING COMPLETE-Power Off-” when
charging is complete.
It takes approximately 3.5 hours to fully recharge a completely
rundown battery. With the Sprint-approved LiIon battery,
you can recharge the battery before it becomes completely
run down.
Section 2: Understanding Your PCS Phone
2A: Your PCS Phone – The Basics 14