To access the system console using the ilom cli – Sun Microsystems X6450 User Manual
Page 39
Chapter 2
Installing and Configuring the Server Module
29
▼ To Access the System Console Using the ILOM CLI
1. Connect and log in to the ILOM as described in
.
The ILOM prompt appears.
2. To power on the system, type the command:
-> start /SYS
Note –
You can also power the system on or off using a stylus, as described in
“Routine Power On and Power Off” on page 3
3. To start the system console, type:
-> start /SP/console
4. To exit the system console, press Esc-Shift-9.
5. To stop the system, type:
-> stop /SYS
▼ To Access the System Console Using the ILOM Web
Interface
Note –
This procedure shows screens from ILOM 2.0. In ILOM 3.0, the procedures
work the same, but the screens might have slight differences.
1. Log on to the web interface as described in
.
The Versions screen appears.