Accessing the system console, To access the system console directly – Sun Microsystems X6450 User Manual
Page 38
28
Sun Blade X6450 Server Module Installation Guide • May 2009
■
To specify a static Ethernet configuration, type:
where xxx.xxx.xx.xx, yyy.yyy.yyy.y and zzz.zzz.zz.zzz are the IP address,
netmask, and gateway for your SP and network configuration.
■
To specify a dynamic Ethernet configuration, type:
set pendingipdiscovery=dhcp
set commitpending=true
Note –
Typing set commitpending=true commits your changes.
Accessing the System Console
This section describes how to connect to the system console.
Choose one of the following ways to access the system console:
■
Directly, using the dongle
■
Using the ILOM CLI
■
Using the ILOM web interface and an RKVM session
After you can view the system console, refer to the documentation for your
operating system. See the Sun Blade X6450 Server Module Operating System Installation
Guide, or the Sun Blade X6450 Server Module Windows Operating System Installation
Guide.
▼ To Access the System Console Directly
1. Connect a keyboard, monitor, and mouse to the dongle cable on the server
module front panel. See
“Dongle Cable Connections” on page 33
.
2. To power the server on or off, use a stylus as described in
set pendingipaddress=
xxx.xxx.xx.xx
set pendingipnetmask=
yyy.yyy.yyy.y
set pendingipgateway=
zzz.zzz.zz.zzz
set pendingipdiscovery=static
set commitpending=true