Sun Microsystems X6450 - Manual (Page 34)

24 Sun Blade X6450 Server Module Installation Guide • May 2009
This procedure also verifies that the ILOM is working correctly and that you can
access it through the CMM ILOM.
▼ To Display the Service Processor’s IP Address
Note – This procedure can be used for ELOM as well as ILOM 2.0 and ILOM 3.0.
1. Log in to the CMM ILOM CLI.
2. Type the command:
show /CH/BL n/SP/network
where n is the server module number or chassis slot ID.
The CMM ILOM displays information about the server module, including its IP
address and MAC address. For example:
Connecting to the ILOM
This section describes how to connect to the ILOM’s CLI and web interface.
-> show /CH/BL0/SP/network
/CH/BL0/SP/network
Targets:
Properties:
type = Network Configuration
commitpending = (Cannot show property)
ipaddress = IPaddress
ipdiscovery = dhcp
ipgateway = IPgateway
ipnetmask = 255.255.252.0
macaddress = Macaddress
pendingipaddress = IPaddress
pendingipdiscovery = dhcp
pendingipgateway = IPgateway
pendingipnetmask = 255.255.252.0
Commands:
cd
set
show
->