Sherwood R-963 - Manual (Page 9)

9
ENGLISH
CENTER SPEAKER FRONT B SPEAKERS
• These outlets are switched on(power-on
mode) and off(standby mode) according
to the power control as follows(Maximum
total capacity is 1A, 100W):
Standby mode – switched AC outlet off
Power-on mode – switched AC outlet on
■ SWITCHED AC OUTLETS
■ AC INLET
P lug the supplied AC input cord into this AC INLET and then
into the wall AC outlet.
To a wall AC
outlet.
• Do not use an AC input cord other than the one supplied with
this unit. The AC input cord supplied is designed for use with
this unit and should not be used with any other device.
• You can connect two sets of front speakers and can select front A or (and) B
speakers according to your taste.
• Never short circuit the + and - speaker wires.
• Be sure to connect speakers firmly and correctly according to the channel
(left and right ) and the polarity ( + and -).
• Only when enjoying either 6.1 or 7.1 channel surround playback, connect
either the surround back left speaker only or both of surround back speakers.
• If you assign the power amplifier for the surround back channels to the
ROOM 2, this receiver can drive the speakers in another room(ROOM 2).
(For details, refer to "ROOM 2 connections" on the previous page and
"SETTING THE POWER AMP ASSIGN" on page 37.)
Notes:
• For safe amplifier operation, in case of using either front A or front B
speakers, use all the speakers with impedance of over 6 Ω. However, in case
of using both front A and front B speakers, use only the front speakers with
impedance of over 12 Ω and other speakers with impedance of over 6 Ω.
• After installing the speakers, first set the connected speakers to the desired
before operating this receiver.(For details, refer to "SETTING THE
SPEAKER SETUP" on page 38.)
■ CONNECTING SPEAKERS
CENTER
SPEAKER FRONT B SPEAKERS
left right
Front B Speakers Front A Speakers
left right Front
center
Surround
left
Surround
back left
Surround
right
Surround
back right