Sherwood R-963 - Manual (Page 40)

ENGLISH
40
Repeat the above steps and until each level is adjusted as desired.
4
Each time these buttons are pressed, “ ” is moved to the
corresponding LFE level mode.
Each time these buttons are pressed, the LFE level can
be adjusted within the range of either -10~0 dB for
Dolby Digital program sources or -10~+10 dB for DTS
and MPEG program sources.
In general, we recommend the LFE level for Dolby
Digital program sources to be set at 0 dB and +10 dB for
DTS program sources.(However, the recommended LFE
level for some early DTS program sources is 0 dB.)
If the recommended levels seem too high, lower the
setting as necessary.
Press the CURSOR UP( )/DOWN( ) buttons to select the LFE LEVEL CONTROL, then press the
ENTER button.
1
Press the CURSOR UP( )/DOWN( ) buttons to select the desired LFE level mode.
2
Press the CURSOR LEFT( )/RIGHT( ) buttons to adjust the selected LFE level as desired.
3
When selecting the LFE LEVEL CONTROL
OFF
OSD POWER
MAIN PAGE FAV
MUTE
CH/ SET
VOL
RETURN
DISC DISP
MI
ROOM 2
1 STEREO
7.1 SURR
CH
2 3
4 5 6
7 8 9
0 ENT
M2 M3
AUTO DSP
RNC-500
OFF
OSD POWER
MAIN PAGE FAV
MUTE
CH/ SET
VOL
RETURN
DISC DISP
MI
ROOM 2
1 STEREO
7.1 SURR
CH
2 3
4 5 6
7 8 9
0 ENT
M2 M3
AUTO DSP
RNC-500
L F E L E V E L C O N T R O L
R E T U R N : B a c k , : S e l e c t
D O L B Y - - - - - + 0 dB
D T S - - - - - + - - - - - 0 dB
M P E G - - - - - + - - - - - 0 dB
OFF
OSD POWER
MAIN PAGE FAV
MUTE
CH/ SET VOL
RETURN
DISC DISP
MI
ROOM 2
1 STEREO
7.1 SURR
CH
2 3
4 5 6
7 8 9
0 ENT
M2 M3
AUTO DSP
RNC-500