Sherwood R-963 - Manual (Page 43)

43
T O N E D E F E A T : Off
T O N E C O N T R O L
R E T U R N : B a c k , : S e l e c t
B A S S - - - - - + - - - - - 0 dB
T R E B L E - - - - - + - - - - - 0 dB
OFF
OSD POWER
MAIN PAGE FAV
MUTE
CH/ SET
VOL
RETURN
DISC DISP
MI
ROOM 2
1 STEREO
7.1 SURR
CH
2 3
4 5 6
7 8 9
0 ENT
M2 M3
AUTO DSP
RNC-500
Press the CURSOR UP( )/DOWN( ) buttons to select the TONE CONTROL, then press the ENTER
button.
1
When selecting the TONE CONTROL
ENGLISH
Note:
When the source direct function is activated, the TONE CONTROL cannot be selected.
Each time these buttons are pressed, the tone defeat mode
changes as follows:
On : Select this when listening to a program source without
the tone effect.
Off : Select this when adjusting tone for your taste .
Note :
When the tone defeat mode is set to On, the tone (bass and
treble) cannot be adjusted.
Press the CURSOR LEFT( )/RIGHT( ) buttons to select the desired tone defeat mode.
2
When the tone defeat mode is set to Off to adjust the tone (bass and treble)
1. Press the CURSOR UP( )/DOWN( ) buttons to select the desired tone mode.
Each time these buttons are pressed, “ ” is moved to the tone defeat mode or the corresponding tone mode.
2. At the desired tone mode, press the CURSOR LEFT( )/RIGHT( ) buttons to adjust the selected tone as desired.
The tone level can be adjusted within the range of -10~+10 dB.
In general, we recommend the bass and treble to be adjusted to 0 dB(flat level).
Extreme settings at high volume may damage your speakers.
3. To complete tone adjustment, repeat the above steps 1 and 2.
OFF
OSD POWER
MAIN PAGE FAV
MUTE
CH/ SET VOL
RETURN
DISC DISP
MI
ROOM 2
1 STEREO
7.1 SURR
CH
2 3
4 5 6
7 8 9
0 ENT
M2 M3
AUTO DSP
RNC-500