Sherwood R-963 - Manual (Page 45)

45
D C T R I G G E R :
T U N E R V I D E O 1
C D V I D E O 2
A U X V I D E O 3
T A P E M O N . V I D E O 4
P H O N O V I D E O 5
Off
D C T R I G G E R
E N T E R : S e t , , , : M o v e
OFF
OSD POWER
MAIN PAGE FAV
MUTE
CH/ SET VOL
RETURN
DISC DISP
MI
ROOM 2
1 STEREO
7.1 SURR
CH
2 3
4 5 6
7 8 9
0 ENT
M2 M3
AUTO DSP
RNC-500
Press the CURSOR UP( )/DOWN( ) buttons to select the DC TRIGGER, then press the ENTER button.
1
When selecting the DC TRIGGER
Each time the CURSOR CONTROL buttons are pressed,
“
” is moved to the corresponding input source.
When the ENTER button is pressed at the desired input
source, “+” is marked it with.
When the input sources marked with “+” on this menu
are selected with the AUDIO and VIDEO SELECTOR
buttons, etc.,the DC trigger function is automatically
activated. (For details, refer to “CONNECTING DC
OUT” on page 7.)
When the ENTER button is pressed at the input source
marked with “+”, “+” is cleared and the DC trigger
function is canceled for this input source.
Repeat this step until the desired input sources are all
selected.
ENGLISH
Each time these buttons are pressed, the DC TRIGGER
mode changes as follows:
On : Select this to activate the DC trigger function.
Off : Select this to cancel the DC trigger function.
Press the CURSOR LEFT( )/RIGHT( ) buttons to select the DC TRIGGER mode as desired.
2
Press the CURSOR UP( )/DOWN( )/LEFT( )/RIGHT( ) buttons to select the desired input source
that uses the DC trigger function, then press the ENTER button.
3
OFF
OSD POWER
MAIN PAGE FAV
MUTE
CH/ SET VOL
RETURN
DISC DISP
MI
ROOM 2
1 STEREO
7.1 SURR
CH
2 3
4 5 6
7 8 9
0 ENT
M2 M3
AUTO DSP
RNC-500
When the DC TRIGGER mode is set to On
OFF
OSD POWER
MAIN PAGE FAV
MUTE
CH/ SET
VOL
RETURN
DISC
DISP
MI
ROOM 2
1 STEREO
7.1 SURR
CH
2 3
4 5 6
7 8 9
0 ENT
M2 M3
AUTO DSP
RNC-500