Sherwood R-963 - Manual (Page 26)

ENGLISH
Adjusting each channel level
Select the desired channel.
3
Adjust the level of the selected channel
as desired.
4
Repeat the above steps and to
adjust each channel level until the sound
level of each speaker is heard to be
equally loud.
5
If you have performed the CH LEVEL TRIM
procedure on the OSD menu, you can skip this
procedure. (For details, refer to “SETTING THE CH
LEVEL TRIM” on page 49.)
Each time this button is pressed, the corresponding
channel is selected and displayed for 3 seconds as
follows:
FRONT-L CENTER(or FRONT-C) FRONT-R SURR-R
SUBWOOFER SURR-L(( SURR-C) or ( BACK-L BACK-R))
Depending on the speaker setting, items set to None
or No cannot be selected.
If the channel display disappears, start from the
above step
again.
OFF
OSD POWER
MAIN PAGE FAV
MUTE
CH/ SET
VOL
RETURN
DISC DISP
MI
ROOM 2
1 STEREO
7.1 SURR
CH
2 3
4 5 6
7 8 9
0 ENT
M2 M3
AUTO DSP
RNC-500
or
MULTI CONTROL
DOWN UP
CH
OFF
OSD POWER
MAIN PAGE FAV
MUTE
CH/ SET VOL
RETURN
DISC DISP
MI
ROOM 2
1 STEREO
7.1 SURR
CH
2 3
4 5 6
7 8 9
0 ENT
M2 M3
AUTO DSP
RNC-500
CH/
SET
or
CHANNEL
SELECTOR
26
Enter the test tone mode.
6
O nly when playing a program source in available
surround modes except the DOLBY VIRTUAL
mode, the volume level of each channel can be
adjusted easily with the test tone function.
Note: When the 7.1 CH DIRECT is selected as an input
source, the test tone function does not work.
At each channel, adjust the level as
desired until the sound level of each
speaker is heard to be equally loud.
7
Cancel the test tone function.
8
Adjusting each channel level with test tone
The test tone will be heard from the speaker of each
channel for 2 seconds as follows:
Front Left Center Front Right Surround Right
Surround Left (( Surround Center) or ( Back Left Back Right))
SUBwoofer
Depending on the speaker setting(None or No), the test
tone of the corresponding channel is not available.
POWER
OFF
OSD
or
TEST TONE
POWER
OFF
OSD
or
TEST TONE
You can select the desired channel and adjust its level
with repeating the steps
and in “Adjusting
each channel level” procedure.
OFF
OSD POWER
MAIN PAGE FAV
MUTE
CH/ SET VOL
RETURN
DISC DISP
MI
ROOM 2
1 STEREO
7.1 SURR
CH
2 3
4 5 6
7 8 9
0 ENT
M2 M3
AUTO DSP
RNC-500
or
MULTI CONTROL
DOWN UP
CH