Setting the room2 feed setup, English, When selecting the volume mode – Sherwood R-963 User Manual
Page 50
ENGLISH
50
The ROOM 2 function allows enjoying one source in the main room while playing another in a different room at
the same time.
The analog signals from the 7.1 CH DIRECT inputs and TAPE MONITOR INs as well as the digital signals
from the coaxial or optical digital input cannot be output from the ROOM 2 OUTs.
Each time these buttons are pressed, the volume mode
changes as follows:
Variable : Select this when an power amplifier is connected
to the ROOM 2(audio) OUTs for ROOM 2 source
playback. You can adjust the ROOM 2 volume
level with the MASTER VOLUME CONTROL
knob of this receiver or the VOLUME
UP/DOWN buttons on the remote control.
Fixed : Select this when an integrated amplifier, etc. is
connected to the ROOM 2(audio) OUTs. You can
adjust the ROOM 2 volume level on the connected
integrated amplifier, etc.
Notes :
When you assign the power amplifier for the surround back channels to the ROOM 2, the volume mode is
automatically set to Variable.
In case that an integrated amplifier, etc. is connected to the ROOM 2(audio) OUTs and the volume mode is set to
Variable, if the ROOM 2 volume level is adjusted to high level on both this receiver and the connected amplifier,
the ROOM 2 speaker and the connected amplifier may be damaged.
Therefore, be sure to set the volume mode to Fixed for safe operation when using amplifier or receiver with its
own volume control for ROOM 2.
When selecting the Fixed mode, first adjust the volume level as desired in the Variable mode and select the
Fixed mode. Then the volume level will be fixed to the adjusted level.
R O O M 2 F E E D S E T U P
R E T U R N : B a c k E N T E R : S e l e c t
V O L U M E M O D E
F U N C T I O N S E L E C T
To select the desired volume mode.
To select the desired ROOM 2 source.
Press the CURSOR UP(
)/DOWN(
) buttons to select the VOLUME MODE, then press the ENTER
button.
1
Press the CURSOR LEFT(
)/RIGHT(
) buttons to select the desired volume mode for the ROOM 2
source.
2
SETTING THE ROOM2 FEED SETUP
OFF
OSD
POWER
MAIN
PAGE
FAV
MUTE
CH/
SET
VOL
RETURN
DISC
DISP
MI
ROOM 2
1
STEREO
7.1
SURR
CH
2
3
4
5
6
7
8
9
0
ENT
M2
M3
AUTO
DSP
RNC-500
When selecting the VOLUME MODE
V O L U M E M O D E
:
Variable
V O L U M E M O D E
R E T U R N : B a c k , : S e l e c t
OFF
OSD
POWER
MAIN
PAGE
FAV
MUTE
CH/
SET
VOL
RETURN
DISC
DISP
MI
ROOM 2
1
STEREO
7.1
SURR
CH
2
3
4
5
6
7
8
9
0
ENT
M2
M3
AUTO
DSP
RNC-500