Siemens ADSL 500 - Manual (Page 65)

Chapter 5: Web Configuration
61
router address and then click Apply. If you want add a rout on WAN side, you should choose
the Interface. Select ATM PVC interface and then click Apply.
Dynamic Routing
Routing Information Protocol (RIP) is utilized as a means of exchanging routing information between routers. It
helps the routers to determine optimal routes. This page allows you to enable/disable this function.
By default, RIP is disabled with Disabled selected. You are allowed to enable RIP over the primary LAN interface.
Upon each interface, you can customize the RIP on Receive Mode and Transmit Mode respectively.
Receive Mode: It incorporates the RIP information when receiving the RIP packets. From the drop-down list
select which RIP version should be accepted, RIP disable, RIPv1, RIPv2 and both.
Transmit Mode: It broadcasts the routing table. From the drop-down list select which RIP version should be
broadcasted, RIP disable, RIPv1, RIPv2 and both.
D D N N S S
DNS Relay
On this page you can choose to disable or enable DNS Relay function. If your DNS is disabled and you choose to
enable DNS relay, after selecting the Enabled option, please click Configure and then specify up to three DNS IP
addresses in the DNS server 1-3 IP address fields. Then click Apply to enable the DNS relay function.
If you log in DNS Relay page for the first time: when you choose Enabled and enter this page by clicking Configure.
The page will show DNS server 1-3 IP address fields specify up to three DNS IP addresses click Apply.