Siemens ADSL 500 - Manual (Page 22)

SANTIS ADSL 50/500 User Manual
18
Chapter 3: Connection Mode
Prior to configuring the ADSL Router, you must decide whether to configure the ADSL Router as a bridge or as a
router. This chapter presents some deployment examples for your reference. Each mode includes its general configure
procedures. For more detailed inforamtion about web configuration, refer to "Web Configuration".
Bridge Mode
Router Mode
MER Mode
PPPoA+ NAT Mode
PPPoE + NAT Mode
Multiple PVCs Mode
For making sure that you can connect the ADSL to your computer well and get into Internet successfully, please
make sure the following first.
1. Make sure you have installed a network interface card onto your computer.
2. Make sure the connection between the ADSL and your computer is OK.
3. Check to see the TCP/IP protocol and set the IP address as “Auto Get IP Address”.
When you are sure all above is Ok, you can open the Browser and type in “192.168.1.1” and start to do the web
configuration with different connection modes.
This chapter is going to introduce the function of each connection mode and tell you the basic configuring steps that
you have to do. If you did not follow the configuring steps for using these connection modes, you might get some
connection problems and can not connect to Internet well.