Woodstock PORTABLECYCLONE W1823 - Manual (Page 31)

-29-
Model W1823 (Mfg. Since 9/10)
SE
RV
IC
E
This procedure covers how to reprogram the RF receiver
to accept the new remote control frequency. Use
these instructions if you ever replace either of these
components, or convert the machine to operate on 220V.
This procedure can also be used to control multiple
models of this machine with one remote control.
To reprogram the remote control, do these steps:
1. DISCONNECT MACHINE FROM POWER!
2. Install a new battery in the remote control.
3. Remove the magnetic switch cover (Figure 37), and
locate the receiver reset button shown in Figure 38.
4. CONNECT THE MACHINE TO POWER.
5. On the receiver (see Figure 38), use an insulated
wooden or plastic dowel to press and hold the reset
button until a triple beep is heard. The original
remote control code is now erased.
6. Press and hold the reset button for 1-second. The
receiver is ready for the new code.
7. On the remote control, press and hold the "ON"
button until a double beep is heard. The remote
control has sent a new code to the receiver that has
been accepted.
8. On the receiver, press the reset button for 1-second.
The new activation code is now stored in the
receiver, and the remote control is operational.
9. DISCONNECT THE MACHINE FROM POWER, and
reinstall the magnetic switch cover.
Remote Control
Reprogramming
Reprogramming the receiver on
this machine is done with the
machine connected to power. As
a result, a hazard for shock, fire,
or machine damage exists. ONLY
a qualified electrician or service
person should do this procedure.
Receiver
(In Magnetic
Switch Box)
Figure 37. Remote control receiver
location.
Figure 38. Remote control receiver.
Reset Button
RF Receiver
Unit