Woodstock PORTABLECYCLONE W1823 - Manual (Page 27)

-25-
Model W1823 (Mfg. Since 9/10)
O
PE
R
ATIO
NS
An RF (radio frequency) remote control receiver ( Figure
32) and hand-held control (Figure 33) allow the dust
collector to be turned ON and OFF from more than
75-feet away or from another room. The range will vary
depending upon the density of materials between the
receiver and the control, and the power level of the
battery in the remote.
Note: If you need to have one remote simultaneously
control more than one Model W1823 dust collector, you
can reprogram additional dust collector receivers to
recognize the remote control currently being used. Refer
to Remote Control Reprogramming on Page 29 to do
this.
The ON/OFF buttons (see Figure 33) turn the dust
collector ON and OFF. The forward or backward buttons
cycle the auto shut down time from always ON, to timed
operation intervals of 2 hours, 4 hours, 6 hours, and 8
hours. When illuminated, the red LED lamp indicates
which timed operation mode the machine is in.
If the motor gets too hot the thermal overload on the
motor will trip, shutting the dust collector down.
If the machine overload trips during operation, do
these steps:
1. Verify that cooling around the motor is not
obstructed and improve ventilation if restricted.
2. Let the motor and electrical circuit cool for 30
minutes.
3. Press the motor reset button (see Figure 34), then
press the ON button on the remote control to restart
the dust collector.
4. If the reset button does not function the first time,
repeat Steps 1–3 as needed until the dust collector
turns ON.
Remote Control
Operation
Receiver
(In Magnetic
Switch Box)
Figure 32. Remote control receiver.
Figure 33. RF remote control.
On/Off Buttons
Hour Intervals
Back
Button
Forward
Button
Figure 34. Reset button on motor.
Motor
Reset
Button