Woodstock PORTABLECYCLONE W1823 - Manual (Page 20)

-18-
Model W1823 (Mfg. Since 9/10)
SE
TU
P
22. Place the drum extension on top of the collection
drum, and orient the window, vacuum hose port, and
the clamp bolt, as shown in Figure 22.
23. Install and tighten the drum clamp, as shown in
Figure 22.
24. Thread the four swivel casters into the underside of
the drum.
25. Fasten the 1 1 ⁄
2
" diameter vacuum hose onto the
collection drum with the 1 3 ⁄
4
" hose clamp, as shown
Figure 22.
Figure 22. Drum and drum extension
positioning and installation.
27. Place the dust collection drum bag in the drum and
roll approximately 2" of the bag over the edge of the
drum.
28. Pull the release lever down to lift the drum cover,
roll the drum under the lid, and push the lever
upward to lower the lid on the drum (see Figure
24).
Note: The lid is not designed to rest on top of the
drum with any real force, nor is it designed to snap
into place to create a seal. Instead, a tight seal is
established by the vacuum created when the dust
collector is in operation.
Figure 25. Canister bag installed.
26. Place two 1 ⁄
4
"-20 acorn nuts in the handle, and
fasten the handle to the drum extension with two
1 ⁄
4
"-20 x 5 ⁄
8
" Phillips head screws, as shown Figure
23.
29. Place the canister bag around the bottom edge of
the canister, and clamp it in place with the quick
release bag clamp, as shown Figure 25.
Congratulations! Assembly is complete.
Vacuum Hose
Drum Clamp
Figure 23. Handle installation.
Acorn Nut
Figure 24. Drum positioning at front of
machine.
Lid Raised Lid Lowered
Window