Woodstock PORTABLECYCLONE W1823 - Manual (Page 19)

-17-
Model W1823 (Mfg. Since 9/10)
SE
TU
P
16. With the cyclone funnel port still open for access to
the hex nuts inside, fasten the ends of the lift cables
to the outside of the cyclone funnel, as shown in
Figure 18, using the pre-installed hex bolts.
17. Slide the 7" hose clamps onto the ports of the
collection drum lid and the cyclone funnel (see
Figure 18).
Tip: You can disassemble the hose clamps for more
clearance to get the clamps positioned over the
hose. To reassemble the clamps, refer to Figure 19.
18. Work the 7" hose onto both ports, position the hose
clamps on the hose, then tighten them.
19. Connect the ground wire between the drum cover
and leg with the included (2) 5 ⁄
16
"-18 x 1 ⁄
2
" flange
screws, as shown in Figure 20. This wire prevents
accumulation of static electricity at the collection
drum.
20. Position the lift cable in the wheel grooves.
Figure 19. Correct hose clamp assembly.
Figure 18. Collection lid installation.
Lift Cable
End
Figure 21. Checking collection lid lift.
Release
Lever
21. Lower the lid release lever and verify that the lower
edge of the lid flange is approximately 25 1 ⁄
2
" above
the floor, as shown Figure 21 so the dust collection
drum can be rolled under the dust collector without
interference from the lid.
— If the drum hits the lid when it is raised, loosen
the hose and reposition the lid higher. Do not
attempt to adjust the cables.
Figure 20. Ground wire location.
Ground Wire
Ground Screw
Flange
Screws