Woodstock D3038 - Manual

Introduction
The Model D3038 Remote Dust Collector Switch ( Figure
1) allows the operator to turn the dust collector ON/OFF
from a distance of up to 75 feet. Read and understand
this entire document before installation to make sure the
Model D3038 fits the intended application.
NOTICE
This switch is designed to be used only on dust
collectors with standard ON/OFF toggle switches.
Due to the nature of magnetic switches, the Model
D3038 WILL NOT function properly if connected
to a machine with this type of switch. If you are
uncertain about the type of switch on your dust
collector, contact the manufacturer for more
information. Do not attempt to bypass the dust
collector switch with this unit.
Use of the Model D3038 for applications other than
dust collectors may cause the unit to fail and will
void the warranty.
The remote control transmitters and receiver
included in this package are programmed
specifically for each other. For this reason,
replacement transmitters are not available for
purchase. If both transmitters are lost or damaged,
an entire new unit must be purchased.
Figure 1. Model D3038.
Figure 2. Inventory.
A
B
D
C
COPYRIGHT © JANUARY, 2011 BY WOODSTOCK INTERNATIONAL, INC.
WARNING: NO PORTION OF THIS MANUAL MAY BE REPRODUCED IN ANY SHAPE OR FORM WITHOUT
THE WRITTEN APPROVAL OF WOODSTOCK INTERNATIONAL, INC. Printed in China #13756JB
Model D3038
REMOTE DUST COLLECTOR SWITCH
Instruction Sheet
Phone #: (360) 734-3482 • Online Tech Support: [email protected] • Web: www.shopfox.biz
Inventory
(Figure 2)
Qty.
A. Receiver Unit ............................ 1
B. Remote Control Transmitters .......... 2
C. Tap Screws ............................... 2
D. Mounting Bracket ........................ 1
Specifications
Voltage .............................. 110V Only
Max. Current .........................15A Peak
Receiver Range ....................... 75 Feet
Control Signal .........................Infrared
Plug/Receptacle Type .................... 5-15
Only connect the Model D3038 to a 110V circuit with a
NEMA 5-15 receptacle. DO NOT connect a dust collec-
tor with a motor larger than 1 1 ⁄
2
HP. Failure to follow
these warnings will void the warranty and could cause
damage to the remote switch and the dust collector.