Woodstock SHOP FOX W1816 - Manual (Page 31)

-29-
W1816 Owner's Manual (Mfg. Since 10/09)
O
PE
R
ATIO
NS
If your machine doesn't have a built in dust port, use
Figure 41 as a guide to determine which size of dust port
to install on your machine.
Write the required CFM for each machine on your sketch,
as shown in Figure 42.
Machine ......... Average Dust Port Size
Table Saw ..................................4"
Miter/Radial-Arm Saw ....................2"
Jointer (6" and smaller) .................4"
Jointer (8"-12") ............................5"
Thickness Planer (13" and smaller) ....4"
Thickness Planer (14"-20") ...............6"
Shaper ......................................4"
Router (mounted to table) ..............2"
Bandsaw ....................................4"
Lathe ........................................4"
Disc Sander (12" and smaller) ...........2"
Disc Sander (13-18") ......................4"
Belt Sander (6" and smaller) ............2"
Belt Sander (7"-9") ........................3"
Edge Sander (6" x 80" and smaller) ....4"
Edge Sander (6" x 80" and larger) ......5"
Drum Sander (24" and smaller) .... 2 x 4"
Drum Sander (24" and larger) ...... 4 x 4"
Widebelt Sander (18" and smaller) .....5"
Widebelt Sander (24"–37" single head)
.................................... 2 x 6"
Widebelt Sander (24"_51" double head)
.................................... 5 x 4"
Figure 41. Typical dust port diameter and
quantity per machine type.
395
395
614
790 395
220
98
Figure 42. Example of the duct layout
sketch with each machine with its CFM.