beautypg.com

Se tu p – Woodstock SHOP FOX W1816 User Manual

Page 17

background image

-15-

W1816 Owner's Manual (Mfg. Since 10/09)

SE

TU

P

8. Connect the two upper stand braces to the upper

stand legs with (4)

3

8

"-16 x

3

4

" hex bolts and (4)

3

8

"

flat washers, as shown in

Figure 13.

Note: Orient the braces so that the off-center third

hole is aligned with the two mounting holes in the

blower housing bracket, as shown in Figure 13.

These mounting holes are for attaching the remote

magnetic switch in the next step.

10. Slide the four stand leg connectors onto the upper

stand legs, then connect them with (16)

3

8

"-16 x

3

4

" hex bolts and (16)

3

8

" flat washers, as shown in

Figure 15.

9. Attach the remote switch assembly to the blower

housing bracket and upper stand brace with (3)

3

8

"-

16 x

3

4

" hex bolts and (3)

3

8

" flat washers, as shown

in

Figure 14.

Note: You may attach the switch assembly to either

side of the blower housing. Keep in mind that you

must have a line-of-sight between the remote

controller and the switch for proper operation.

Refer to Remote Control on Page 24 for additional

information.

Figure 15. Stand leg connector attached

to the upper stand leg.

Leg

Connector

x 16

Figure 14. Remote magnetic switch

attached.

x 3

Figure 13. Upper stand brace connected

to the upper stand legs.

Align

These

Holes

Upper Stand Brace

x 2