Assembly, Notice – Woodstock SHOP FOX W1816 User Manual

Page 15

-13-

W1816 Owner's Manual (Mfg. Since 10/09)

Assembly

The safest and most efficient method of assembling your

dust collector is to turn the blower housing assembly

upside down and attach the parts upward, as instructed

in the following steps.

Tools & Items Needed

Qty

Wrench 8mm .....................................................1

Wrench 12mm ...................................................2

Wrench 14mm ...................................................1

Phillips Screwdriver #2 .........................................1

Shop Scissors or Knife ..........................................1

Stable Platforms (at least 18" high) ...........................2

To assemble your dust collector, do these steps:

1. After removing the crate from the shipping pallet,

set the smaller items aside in a safe location.

2. With help from other people, place the blower

housing assembly upside down on two saw horses

that are at least 18" from the floor and that can fully

support the weight (see

Figure 7 for an example).

Note: Take care not to damage the attached switch

assembly and electrical cords as you turn the blower

housing assembly over, and make sure that the

motor is not supporting any weight.

3. Attach the 3 x 6mm foam tape to the top of the

intake barrel and cyclone funnel, as shown in

Figures 8–9.

Note: The intake barrel top is the edge closest to

the intake port.

Figure 7. An example of the blower

housing assembly upside down for further

assembly steps.

NOTICE

Using air tools to tighten the fasteners in the

assembly of your dust collector may crack or chip the

paint because of their high torque. We recommend

that you use hand tools or an electric tool with a low

clutch setting.

Figure 9. Funnel foam tape attached.

Tape

Figure 8. Intake barrel foam tape

attached.

Tape