beautypg.com

Test run – Woodstock SHOP FOX W1816 User Manual

Page 24

background image

-22-

W1816 Owner's Manual (Mfg. Since 10/09)

SE

TU

P

Once the assembly is complete and before you connect to

any duct lines, test run your machine to make sure it runs

properly.

If, during the test run, you cannot easily locate the source

of an unusual noise or vibration, stop using the machine

immediately, then review the

Troubleshooting guide on

Page 39.

If you still cannot remedy a problem, contact our Tech

Support at (360) 734-3482 for assistance.

Note: Without any inlet flow constriction, the motor

will work the hardest and draw maximum amps. If this

condition should trip the circuit breaker, connect the inlet

port to your duct system or a duct hose with a blast gate

closed half-way.

To test run the machine, do these steps:

1. Make sure you have read the safety instructions at

the beginning of the manual and that the machine is

setup properly.

2. Make sure all tools and objects used during setup are

cleared away from the machine.

3. Review the Electrical requirements on Page 9 and

connect the machine to the power source.

4. Press the start switch to allow power to flow to the

magnetic switch—the power light will illuminate

(see

Figure 31). Refer to Basic Controls on Page 24

for additional details on the controls for your dust

collector.

5. Press the ON/OFF button to turn the machine

ON—the run light will come on. Make sure your hand

is poised over the start switch in case you need to

quickly turn the machine OFF.

Test Run

6. Listen and watch for abnormal noises

or actions. The machine should run

smoothly with little or no vibration or

rubbing noises.

— If you suspect any problems,

immediately turn the machine OFF

and disconnect the machine from

power. Refer to the

Troubleshooting

guide on

Page 39 to identify and fix

any problems.

— If you cannot solve the problem

with the use of the

Troubleshooting

guide, contact our Tech Support at

(360) 734-3482 for assistance.

7. Press the timer button on the

magnetic switch and cycle through

each of the times to make sure the

appropriate indicators light.

8. Press the timer button on the remote

control and cycle through the times in

the same manner as

Step 7.

9. Toggle the ON/OFF button on both

the magnetic switch and the remote

control to make sure they are working

properly.

Figure 31. Machine controls.

Remote

Control

Start

Switch

ON/OFF

Button