Siemens 2602 - Manual (Page 22)

4-1
C HAPTER 4
I
NSTALLING AND
C
ONFIGURING
TCP/IP
To access the Internet through the SpeedStream 2602 DSL/Cable Router, you must configure it and your
network computers with same IP subnet. Manually configure the IP address for client computers or obtain
it automatically from the SpeedStream 2602’s DHCP service.
The default network settings for the SpeedStream 2602 are:
IP Address: 192.168.254.254
Subnet Mask: 255.255.255.0
Password:
admin
You can change these settings to comply with your network requirements; however, you must first
configure at least one computer to access the SpeedStream 2602 management interface.
Install the TCP/IP Protocol
If TCP/IP is not installed on your computer, follow these instructions:
1. Click Start/Settings; then click Control Panel.
2. Double-click Network to display the Configuration tab in the Network window.
3. Click Add to add a network component to your computer.
4. Double-click Protocol to add the TCP/IP protocol.
Figure 4-1. Select Network Component Type
5. In the manufacturers list, select Microsoft; then select TCP/IP in the Network Protocols list. Click
OK to return to the Network window.