Star Micronics RS232 - Manual (Page 25)

– 21 –
STAR MODE
8. CONTROL CODES/STAR MODE
8-1. Star Mode Command Summary
The details of each command are shown in the following sections.
Commands to Select Characters
Control codes
Hexadecimal
Function Page
codes
“R” n 1B 52 n Select international character set 25
“/” “1” 1B 2F 31
Select slash zero 25
“/” <1> 1B 2F 01
“/” “0” 1B 2F 30
Select normal zero 25
“/” <0> 1B 2F 00
“b” n1 n2 n3 n4 1B 62 n1 n2 n3 n4
Select bar code printing 26
d1 ... d1 ... 1E
“M” 1B 4D Select 12-dot pitch printing 30
“p” 1B 70 Select 14-dot pitch printing 30
“P” 1B 50 Select 15-dot pitch printing 30
“:” 1B 3A Select 16-dot pitch printing 30
n 1B 20 n Set character spacing 30
0E Sets the printing magnified double in
31
character width.
14 Resets the printing magnified in
31
character width.
“W” n 1B 57 n Sets the magnification rate in character width. 31
1B 0E Sets the printing magnified double in
31
character height.
1B 14 Resets the printing magnified in character
31
height.
“h” n 1B 68 n Sets the magnification rate in character height. 32
“i” n1 n2 1B 69 n1 n2 Sets the magnification rates in character
32
width and height.
“–” “1” 1B 2D 31
Select underlining 32
“–” <1> 1B 2D 01
“–” “0” 1B 2D 30
Cancel underlining 32
“–” <0> 1B 2D 00
“_” “1” 1B 5F 31
Select upperlining 33
“_” <1> 1B 5F 01
“_” “0” 1B 5F 30
Cancel upperlining 33
“_” <0> 1B 5F 00